Draw-Tite 75382 MAX-FRAME RECEIVER - Manual

Installation Instructions
Hummer H3
Part Numbers:
44177
75382
87406
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 21mm
Drill Bits: None
1. Remove 2 bolts from outside of each frame rail (see figure 2). Retain blots for installation of hitch.
2. Raise hitch into position.
Note: Lowering exhaust may ease installation.
3. Reinstall M14 fasteners removed in Step 1.
Rev. A 6-8-05 75382N Sheet 1 of 3 z 2005 Cequent Towing Products
Tighten all M14 CL10.9 fasteners with torque wrench to 148 Lb.-Ft.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75382F or 87406F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
500 5,000
Weight Carrying
Ball Mount
500 5,000 Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV6
Form: F205 Rev A 5-6-05
Figure 1
Figure 2
Outside of frame rail