Draw-Tite 75270 MAX-FRAME RECEIVER - Manual

Installation Instructions
Honda Odyssey
Part Numbers:
75270
44174
87479
78234
U-HAUL
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 18mm
Drill Bits: None
1999-2004 Models
Use forward slot
Existing weld nuts
Note: If present, remove plastic appearance panel which covers driver’s side frame rail. Return appearance panel and fasteners
to vehicle owner.
1. Lower vehicle exhaust and raise hitch into position.
2. Install the six (6) M12 fasteners and blocks as shown above.
Note: 1999-2004 models use the most forward slots in the hitch side brackets.
3. Re-install vehicle exhaust.
z 2004, 2006, 2008, 2009, 2010, 2011 Cequent Performance Products Sheet 1 of 3 75270N 07/14/11 Rev. J
j
Qty. (6) Bolt M12 X 1.25 X 35mm
l
Qty. (6) Conical Washer
Tighten all M12 Cl8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75270F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing 5000 (2270 Kg) 500 (227 Kg)
Weight Carrying
Ball Mount
3500 (1589 Kg) 350 (159 Kg)
Wiring Access Location: SUV3
Form: F205 Rev A 5-6-05
Frame rail
2005 & Later Models
Installation shown
Fascia
Frame rail
k
j
Note: Fasteners typical both sides
k
Qty. (6) 1/4“ X 1-1/2“ X 2” Blocks
l