Draw-Tite 75547 MAX-FRAME RECEIVER - Manual

Installation Instructions
Honda CR-V
Part Numbers:
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 17mm, 11/16
Drill Bits: None
Existing
weldnuts
typical
k
j
z 2007, 2011 Cequent Performance Products Sheet 1 of 3 75547N 6-21-11 Rev. B
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: 75547F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Wiring Access Location:
Form: F205 Rev A 5-6-05
Hitch type
Max Gross
Trailer WT (LB)
Max Tongue
WT (LB)
Weight Distributing Not For Use With Spring Bars
Weight Carrying
Ball Mount
3500 (1589 Kg) 525 (238 Kg)
75547
87440
44575
Tighten all 3/8-16 GR5 fasteners with torque wrench to 30 Lb.-Ft. (41 N*M)
Tighten all M10 CL8.8 fasteners with torque wrench to 38 Lb.-Ft. (52 N*M)
1. Lower exhaust by removing rubber isolators from muffler hangers. Remove the outside isolator first then the inside isolator.
Spraying a lubricant or soapy water on the metal hanger rod and the rubber isolator helps removal.
2. Raise hitch into position.
3. Install M10 fasteners as shown.
4. Install the 3/8 U-Bolt through the vehicle tie down hook and through the tie down hook attachment of the receiver. Install flat
washer, lock washers and 3/8 hex nuts as shown above.
5. Tighten all fasteners to the required torque specification.
6. Raise exhaust back into position and re-install rubber isolators.
Inside isolator
Note:
Fasteners typical both sides
Exhaust shown lower
m
n
o
l
Tie
down
hook
j
Qty. (4) Hex Bolt M10X1.25X30 CL8.8
m
Qty. (2) Flat Washer
k
Qty. (4) Conical Washers
n
Qty. (2) Lock Washer
l
Qty. (1) 3/8-16 U-Bolt
o
Qty. (2) 3/8 Hex Nut
Fascia
Frame rail