Draw-Tite 36292 FRAME HITCH - Manual

Installation Instructions
CHEVROLET MONTE CARLO
Part Numbers:
06358
36292
90150
Hitch Shown In Proper Position
Wiring Access Location: PC3, PC4
Equipment Required:
Wrenches: 13mm, 7/8
Drill Bits: None
1. Lower vehicle exhaust.
2. Remove three (3) existing bumper mounting bolts from each side and return to vehicle owner.
3. Insert hitch between bumper bracket and frame rail. Install supplied M8 fasteners as shown above.
4. Use pull wires to feed the carriage bolts and blocks into frame rails though access holes as shown.
5. Install remaining fasteners as shown above.
6. Raise vehicle exhaust.
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Rev. B 01-31-06 N36292 Sheet 1 of 3 z 2006 Cequent Towing Products
Pull Wire, 1/2” Qty. (2) 6 Lock Washer, 1/2” Qty. (2) 3
Bolt with Conical Washer, M8 x 1.25 x 55mm Qty. (6) 5 Spacer, 1/4” x 1-1/2” x 2” Qty. (2) 2
Hex Nut, 1/2” Qty. (2) 4 Carriage Bolt, 1/2”-13 x 1-3/4” Qty. (2) 1
Tighten all M8 CL9.8 fasteners with torque wrench to 25 Lb.-Ft (34 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
3500 LB Max Gross Trailer Weight
300 LB Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
36061
Fastener Kit: K36292
Fascia
Access Hole
Frame Rail
Exhaust Hanger
Bumper Bracket