Draw-Tite 36510 FRAME HITCH - Manual

Installation Instructions
HYUNDAI TUCSON
KIA SPORTAGE
Part Numbers:
36510
90211
06132
Hitch Shown In Proper Position
Wiring Access Location: SUV1, SUV2 (Tucson)
SUV1, SUV5 (Sportage)
Equipment Required:
Wrenches: 16mm
Drill Bits: NONE
z 2011, 2012 Cequent Performance Products
Sheet 1 of 3 36510N 1-9-12 Rev. B
j
Qty. (4) Hex Bolt – M10 x 1.25 x 30mm CL 10.9 k
Qty. (4) Conical Washer – 3/8”
Tighten all M10 CL 10.9 fasteners with torque wrench to 42 Lb.-Ft. (57 n*m)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Fastener Kit: 36510F
Form F206 Rev A 5605
1. Raise vehicle with hoist or ramps for access to underside.
2. While supporting exhaust remove rear hangers and lower exhaust until hitch can be positioned over the
muffler tips and into position aligning slots in hitch with existing weld nuts in the bottom of frame.
3. Loosely install the M10 hex bolts with conical washers, (4) four places, as shown.
4. Tighten all M10 CL10.9 fasteners with torque wrench.
5. Reinstall rear hangers for exhaust.
FASCIA
j k
j k
FRAME
EXISTING WELD NUTS
BOTH SIDES
KIA SPORTAGE
HYUNDAI TUCSON
Drawbar Kit:
36001
3500 Lb. (1589 kg) Max Gross Trailer Weight
300 Lb. (136 kg) Max Tongue Weight