Draw-Tite 36311 FRAME HITCH User Manual
Installation instructions, Subaru forester, Part numbers
Installation Instructions
SUBARU FORESTER
Part Numbers:
36311
06975
90757
Hitch Shown In Proper Position
Wiring Access Location: SUV4
Equipment Required:
Wrenches: 12mm, 14mm, 17mm
Drill Bits: None
1.
Lower carbon canister and bracket from passenger side of frame.
2.
Remove the tie-down bracket from vehicle frame.
3.
Remove center fascia mounting bracket if present.
4.
Remove exhaust mounting bracket from vehicle frame. (Return tie-down brackets, exhaust mounting bracket, center fascia
bracket & fasteners to vehicle owner for reinstallation if hitch is removed).
5.
Bolt hitch to vehicle. Sandwiching carbon canister bracket between hitch and frame. Using fasteners provided as shown
above.
6.
Bolt rubber exhaust hanger to hitch side bracket using fasteners provided as shown above.
7.
Reattach carbon canister to carbon canister bracket.
8.
Reattach center fascia tab if present to hitch with existing fastener or cable tie provided.
Rev. A
8-10-05
N36311
Sheet 1 of 3
z
2002
,
2005 Cequent Towing Products
8
7/16 Flat Washer
Qty. (2)
4
Cable Tie
Qty. (1)
7
M10 X 1.50 Hex Bolt
Qty. (1)
3
M10 X 1.25 Hex Nut
Qty. (1)
6
1/2 Conical Washer
Qty. (7)
2
7/16 Lock Washer
Qty. (1)
5
M12 X 1.25 X 40mm Hex Bolt
Qty. (7)
1
Tighten all M12 CL10.9 fasteners with torque wrench to 92 Lb.-Ft.
Tighten all M10 fasteners with torque wrench to 20-30 Lb.-Ft.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
3500 LB Max Gross Trailer Weight
300 LB Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
36051 OR 90001
Fastener Kit: F36311 OR 90757F
Carbon Canister
Plastic Bumper Fascia
Attach Center Fascia Tab Here
Using Cable Tie Provided
Tie-down
Bracket
Existing Weld nut
Carbon Canister Bracket
Frame
Tie-down Bracket
Exhaust Mounting Bracket