Installation instructions, Chevrolet sonic 4 door sedan, Picture 1. picture 3 – Draw-Tite 24876 SPORTFRAME HITCH User Manual
Page 2: Picture 2, Part numbers
Installation Instructions
Part Numbers:
24876
60293
77251
Tighten 7/16”-Gr.5 Carriage Bolts with torque wrench to 50 Lb.-Ft. (68 N*M), Tighten 8mm-CL 9.8 Bolts with torque wrench to 25 Lb.-Ft. (34 N*M)
© 2011 Cequent Performance Products
Sheet 2 of 6
24876N
10-13-11
Rev. A
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Clip is made in two
pieces. After prying out
other half pull this piece
out of bumper fascia.
8mm Bolt shown going through
10mm nut after removing
existing 10mm bolt.
Spacer Block goes
behind this surface.
Chevrolet Sonic 4 Door Sedan
All models including LS, LT & LZ
Picture 1.
Picture 3.
Plastic Fascia Clip
Picture 2.
Clip is made in two
pieces. Pry this half out
with small flat tip
screwdriver.
Hitch shown unpainted
for clarity
Can you see it?