Audiovox XMB10 - Manual (Page 14)

128-7546
14 of 16
-14-
Troubleshooting
System does not turn on
XMB10 does not operate using
batteries
Intermittent operation
ANTENNA error message
NO SIGNAL message
No sound from XMB10 speakers
Receiver power is set to off
Batteries not installed or installed incorrectly
As long as the AC power connector is at-
tached to the rear panel, operation is disabled
Low battery level
Satellite antenna not connected to XMB10
rear panel
Xpress Receiver not firmly seated in cradle
mounting plate
Check for obstacles over or around antenna
Headphones installed
Turn Receiver power on using
the Xpress Power On/Off button
Install batteries observing correct
polarity
Remove power connector from rear
panel of XMB10
Replace batteries
Connect satellite antenna to XMB10
rear panel ANT jack
Press firmly down on the Receiver to
ensure that the connector is firmly
mated to the Boom Box connector
Change location to eliminate nearby
obstacles (bridges, etc.)
Remove headphones
FAULT PROBABLE REMEDY
CAUSE