Adcom GFP-815 - Manual (Page 5)

Description
of Unit: Front Panel
[1] Standby button
Toggles the GFP-815 in and out of
Standby mode. When in standby
mode, the GFP-815 is activated by
pressing either the remote control
power button or toggling the front
panel power switch. When the GFR-
815 is active, the LED indicator in the
Standby button will illuminate.
[2] IR Sensor
This lens protects the infrared receiv-
er which receives commands from the
remote control. Note: the pathway
between the lens and remote control
must be free of obstruction for the re-
mote control to operate the GFP-815.
[3] Headphones Jack
Headphones may be used through the
use of the phones output jack on the
front panel. This jack will accept a
standard 1⁄4” stereo headphone plug.
[4-7] Source Selections
These seven buttons select the source
you desire for listening. When you se-
lect phono(1), 2, 3, 4, 5, 6 or mp3(7),
the selected source is also routed to
the record outputs. The seven source
select buttons are also available on
the remote control.
[8] Tone Button
This button is used to engage the bass
and treble controls. In the out posi-
tion, the tone controls will have no
effect.
[9] MP3 IN Jacks
Mp3 devices can be connected to the
mp3 input jack on the front pan-
el(3.5mm) or the mp3 RCA jacks on
the back panel.
[10] Bass & Treble Knobs
The bass and treble knobs control the
bass and treble frequencies by in-
creasing or decreasing levels.
[11] Balance Knob
Balance control provides adjustment
for greater accuracy of stereo imag-
ing.
[12] Mute Button
Pressing this button mutes the main
outputs. To turn the mute feature off,
press the mute button again. Note:
turning the volume knob on the front
panel will not deactivate the mute
feature.