Draw-Tite 24659 SPORTFRAME HITCH - Manual

6
4
5
1
Installation Instructions
BUICK CENTURY, OLDSMOBILE INTRIGUE,
PONTIAC GRAND PRIX
Part Numbers:
N77109
N24659
N60833
Hitch Shown In Proper Position Wiring Access Location: PC3, PC4
Equipment Required:
Wrenches: 7/8”
Drill Bits: 1/2”
1. ENLARGE EXISTING HOLES IN BUMPER TO 1/2”.
2. REMOVE SPARE TIRE AND TRUNK PAN RUBBER PLUGS.
3. RAISE HITCH INTO POSITION AND ATTACH WITH FASTENERS AS SHOWN ABOVE.
4. SEAL HOLES IN TRUNK PAN TO PREVENT INTRUSION OF EXHAUST FUMES AND WATER.
5. REINSTALL SPARE TIRE.
Rev. B 04-04-06 N24659 Sheet 1 of 3 z 2006 Cequent Towing Products
BLOCK 1/4” X 1-1/2” X 2” Qty. (2) 6 LOCK WASHER – 1/2” Qty. (2) 3
CONICAL TOOTHED WASHER Qty. (2) 5 BLOCK 1/4 X 2-1/2 X 6 Qty. (1) 2
NUT 1/2”-13 Qty. (4) 4 CARRIAGE BOLT 1/2”-13 X 1-3/4” Qty. (4) 1
Tighten all 1/2 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2000 LB Max Gross Trailer Weight
200 LB Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3592
Fastener Kit: K24659
1
2
3
4
TRUNK PAN
REMOVE
RUBBER PLUG
BUMPER
ENLARGE
EXISTING
HOLES
Form F206 Rev A 5605