Draw-Tite 24757 SPORTFRAME HITCH - Manual

Installation Instructions
Hyundai Sonata
Part Numbers:
77133
24757
60816
Hitch Shown In Proper Position Wiring Access Location: PC3, PC4
Equipment Required:
Wrenches: 10mm, 18mm, 9/16
Drill Bits: None
NOTE:
On vehicles with single exhaust, remove appearance panel which covers driver’s side frame rail by removing seven fasteners.
Return appearance panel and fasteners to vehicle owner.
1. Lift hitch into position and install u-bolt over vehicle tow hook and down thru holes in vehicle center bracket. Install 3/8” flanged
locknuts.
2. Install M10 bolts and conical toothed washers thru frame straps into existing weld nuts in vehicle frame rails, one per side.
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft.
Rev. B 11-3-05 24757N Sheet 1 of 3 z 2005 Cequent Towing Products
Conical Toothed Washer Qty. (2) 4 3/8-16 Flanged Locknut Qty. (2) 2
M10 x 1.25 x 40mm Hex Bolt Qty. (2) 3 3/8-16 U-Bolt Qty. (1) 1
Tighten all 3/8 GR2 fasteners with torque wrench to 20 Lb.-Ft.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2000 LB Max Gross Trailer Weight
200 LB Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3592
Or
6803
Fastener Kit: 24757F or 60816F
Form F206 Rev A 5605
Vehicle Frame Rail
Vehicle Tow Hook
Fascia