Draw-Tite 24905 SPORTFRAME HITCH User Manual
Installation instructions, Hyundai elantra gt, Part numbers
Installation Instructions
Hyundai Elantra GT
Part Numbers:
24905
60336
77292
Hitch Shown In Proper Position
Wiring Access Location: PC3, 4
Equipment Required:
Wrenches: 3/4”, Crowfoot adaptor
1
Fascia
1.
Place carriage bolt and spacer onto tow hook. As shown Figure 1.
2.
Raise hitch into position behind end panel and fasten to tow hook with conical washer and hex nut. Hand tighten.
3.
Using Pull wire provided Install Carriage bolt and spacer through the end panel and hitch with conical washer and
hex nut. Hand tighten.
4.
Tighten all fasteners to specification listed below.
z
2013 Cequent Performance Products
Sheet 1 of 3
24905N
1-8-13
Rev. A
1
1
1
1
Qty. (3)
Carriage bolt ½-13 x 1.75 GR5
4
4
4
4
Qty. (3)
Hex nut ½-13
2
2
2
2
Qty. (1)
Spacer
5
5
5
5
Qty. (2)
Spacer
3
3
3
3
Qty. (3)
Conical washer
6
6
6
6
Qty. (1)
½” Pull wire
Tighten all ½” Gr5 fasteners with torque wrench to 75 Lb.-Ft. ( 102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3594
Fastener Kit: 24895F
Form F206 Rev A 5605
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (91 Kg) Max Tongue Weight
3
4
3
4
End panel
Tow hook
Tow hook
Figure 1.
2
5
5
Accessory Rating
A