Draw-Tite 24797 SPORTFRAME HITCH - Manual

Installation Instructions
Kia Rondo
Part Numbers:
60874
24797
77169
Hitch Shown In Proper Position
Wiring Access Location: SUV1, SUV2
Equipment Required:
Wrenches: 10mm, 12mm, 13mm,
14mm, 17mm
Drill Bits: None
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg.) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise position only.
Drawbar Kit:
3594
Fastener Kit: 24797F
Fascia
Existing weldnuts
In vehicle frame
Remove existing bolt
This location
3 3 3 3
4 4 4 4
24915
U-Haul
Accessory Rating B
1. Lower exhaust by disconnecting muffler from rubber exhaust hangers, (3) places.
2. Temporarily remove exhaust heat shield. Retain heat shield and fasteners for reinstallation after hitch is installed.
3. On driver’s side, remove tie-down hook. Return tie-down hook and fasteners to vehicle owner.
4. Remove fasteners at end of frame rail as shown above and discard.
5. Raise hitch into position and install fasteners into existing weldnuts as shown above.
Tighten all M8 CL8.8 fasteners to 20 lb.-ft. (27 N*M)
Tighten all M10 CL8.8 fasteners to 38 lb.-ft. (52 N*M)
6. Reinstall heat shield.
7. Raise exhaust back into position.
z 2007, 2013 Cequent Performance Products, Inc Sheet 1 of 3 24797N 5-9-13 Rev. B
1 1 1 1 Qty. (2) Hex Bolt M10 x 1.25 x 40mm CL8.8 3 3 3 3 Qty. (3) Hex Bolt M8 x 1.25 x 30mm CL8.8
2 2 2 2 Qty. (2) Conical Washer 7/16” 4 4 4 4 Qty. (3) Conical Washer 3/8”
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
Form F206 Rev A 5605
Remove existing bolt
This location
3 3 3 3
4 4 4 4
1 1 1 1
2 2 2 2