Draw-Tite 24915 SPORTFRAME HITCH - Manual

1. Lower exhaust by removing the rubber exhaust hanger.
2. Remove the inner wheel well and splash guards from vehicle, both sides.
3. Remove tow hook from passenger’s side frame rail and return to vehicle owner.
4. Raise hitch into position and loosely install the M10 bolts and conical toothed washers as shown.
5. Pull hitch rearward and tighten all fasteners using a torque wrench as specified below.
6. Reinstall muffler hanger.
7. Reinstall the inner wheel well and splash guards.
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
INNER WHEEL WELL / SPLASH GUARD
REMOVE FASTENERS
Installation Instructions
Kia Soul
Part Numbers:
24915
60347
77302
Hitch Shown In Proper Position
Wiring Access Location: SUV3,4
Equipment Required: Torque wrench
Wrenches: 17mm Socket and Ratchet Wrench,
Phillips screw driver
Drill Bits: None
2000 LB (908 Kg.) Max Gross Trailer Weight
200 LB (90.8 Kg.) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3593
Fastener Kit: 24915F
Fascia
1 1 1 1 Qty. (4) Hex Bolt, M10 x 1.25 x 30mm CL8.8 2 2 2 2 Qty. (4) Conical Toothed Washer 3/8”
z 2014 Cequent Performance Products – Printed in México Sheet 1 of 3 24915N 1-24-14 Rev. A
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
EXISTING WELDNUTS
Accessory Rating A
1 1 1 1
2 2 2 2