Draw-Tite 24903 SPORTFRAME HITCH - Manual

Installation Instructions
Kia Forte
Part Numbers:
Hitch Shown In Proper Position
Wiring Access Location: PC3,PC4
Equipment Required: Lubricant or Soapy water
Wrenches: 17mm,
Bulkhead
1. Lower exhaust system at the rear rubber isolator leaving the rubber isolator in place on the vehicle. Spraying a lubricant on the metal hanger
rod and the rubber isolator helps removal
2. Lift hitch into position, passengers side first. Place crosstube over top of tail pipe. Rotate into position on the outside of the frame rail. It may
be necessary to pull the fascia gently out of the way.
3. Raise the drivers side of the hitch up so it’s on the outside of the frame rails and in front of bulkhead (rotate as needed). Once again, it may be
necessary to pull the fascia gently out of the way.
4. Attached remaining fasteners as shown.
5. Push hitch toward the rear of the vehicle.
6. Tighten all fasteners to the required torque specification.
7. Reattach rubber muffler hanger.
© 2013 Cequent Performance Products Sheet 1 of 3 24903N 7-18-13 Rev. B
1 1 1 1 Qty. (4) Hex bolt M10 X 1.25 X 30mm CL8.8 2 2 2 2 Qty. (4) Conical washer 3/8”
Tighten all M10 CL 8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise position only.
Drawbar Kit:
3594
Fastener Kit: 24903F
Form F206 Rev B 5605
24903
60335
77290
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Note: Fasteners typical
both sides
Existing weld nuts
Both sides.
12
Frame rail
Tail pipe
Fascia
Frame rail
Rearward
Accessory Rating A
Printed in Mexico