Draw-Tite 24710 SPORTFRAME HITCH - Manual

Installation Instructions
Subaru Impreza
Including Outback Sport & WRX
Except WRX STi
Part Numbers:
24710
77091
60823
Hitch Shown In Proper Position Wiring Access Location: PC3, PC4
Equipment Required:
Wrenches: 14mm, 16mm, 17mm, 5/8 & 11/16
Drill Bits: None
Tighten all M12 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Rev. F 7-31-06 N24710 Sheet 1 of 3 z 2001, 2003, 2005, 2006 Cequent Towing Products
Nut 7/16 Qty. (1) 4 Flat Washer 7/16 Qty. (8) 2
Lock Washer 7/16 Qty. (1) 3 Hex Bolt 7/16 Qty. (1) 1
Tighten all 7/16” fasteners until Lock Washer is flat.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
RISE position only.
Drawbar Kit:
3593
Fastener Kit: F24710
1. If present, lower carbon canister and bracket from passenger side of frame.
2. Remove tie-down brackets from vehicle frame.
3. Remove exhaust mounting bracket from vehicle frame. (Return tie-down brackets, exhaust Mounting bracket & exhaust
mounting fastener to vehicle owner for reinstallation if hitch is removed.)
4. Bolt hitch to vehicle using existing fasteners as shown. Push hitch toward driver’s side and tighten all fasteners to torque
as listed.
4. Bolt rubber exhaust hanger to hitch side bracket using fasteners provided as shown.
5. Reattach carbon canister and bracket to vehicle.
Fascia
Tie-down bracket
Exhaust mounting
bracket
Frame
Carbon
canister
bracket
Existing weldnuts
Tie-down bracket
Existing M12 bolts
Push hitch toward drivers side.