AIPTEK V2T6 - Manual (Page 4)


To insert a memory card, do the following:
(1) Open the battery cover.
(2) Gently push the card as indicated until the card reaches the bottom of the slot.
To remove the memory card, gently push it down and it will pop up. Then pull the card
out of the slot.
Inserting a memory card (optional)
Please charge the battery at least 8 hours prior to its first use.
1. Connect the cable.
Connect one end of the supplied AC adapter to the USB port of the
camcorder and the other end to a wall outlet.
OR
Connect one end of the supplied USB cable to the USB port of
the camcorder and the other end to a powered PC. Make sure the
camcorder is powered off.
2. The charging LED turns red and the charge starts.
3. When the charging is interrupted or the battery pack is fully charged, the charging LED
will turn green.
When using a PC to charge the battery, do not power on the camcorder, or
the charge will stop.
Installing the battery
1. Slide the battery cover open.
2. Place the included Li-Ion battery into the compartment. Note that
the metallic contacts must be aligned with the contacts in the
compartment.
3. After the battery is properly installed, replace the battery cover.
Charging the battery
Open the LCD monitor or press and hold down the Power button for 1 second to turn
on the camcorder.
To turn off the camcorder, press and hold down the Power button for 1 ~ 3 seconds or
close the LCD monitor.
Turning on/off your camcorder
If the camcorder stays inactive for a long period of time, it may automatically
shut down due to the Auto-Off setting.