Draw-Tite 59403 BIKE CARRIER - TX W_TILT - HITCH MOUNT - Manual

Product Code:
Product Name:
www.rolaproducts.com
Cequent Towing Products - Plymouth, MI
Technical Service: (888) 521-0510
PRINTED IN CHINA
59400N Rev E 11/23/09 59400N Rev
59400 / 59403
Nylon Washer
ASSEMBLY INSTRUCTIONS
To attach Main Support tube to collar bracket:
1.
Use key to unlock lock on Collar Bracket.
2. Pull spring loaded release pin on side of Main Support tube, remove handle mechanism, and rotate bike Support
Arms into the UP position. Re-insert the handle mechanism. Pull out the spring loaded release pin and push handle
all the way down. Let the spring loaded pin go so that it fully engages the handle mechanism (see Diagram 1).
3. Attach Main Support tube to Collar Bracket in orientation shown (see Diagram 2). Line up the hole near end of main
support tube with the slotted hole in collar bracket and install one (1) ½” x 3-1/4” lg. hex bolt, two (2) nylon flat
washers, and locknut as shown. Tighten locknut until it is snug against the flat washers.
4. Lock Collar Bracket to Main Support tube so bike carrier is in the upright position.
1/2” x 3-1/4” Hex Bolt
Please read all instructions carefully before assembly, installation and/or use of this product.
Flip Shank Operation:
Your Rola (2 or 3) place bike carrier is pre- assembled with our patented flip shank design to be used with a 2” or 1
¼” receiver hitch.
Remove security pin and clip from carrier shank. Rotate shank to appropriate size for you hitch receiver. Replace security
pin and clip as shown in diagram 3 .
1- 1/4” Shank
2” Shank
Clip
Pull Pin
½” Locknut
Diagram 1
Diagram 2
Diagram 3
Handle Mechanism
Release
Pin
2 / 3 Place Bike Carrier - Folding