Draw-Tite 7507 CARGO CARRIER - POLYPROPYLENE - Manual

WARNING: When loaded, the cargo carrier contents should not impair the visibility of the high-mounted stop light, the license
plate and its light, or any other required lights. If it does impair the visibility of any required elements, you may need
the optional cargo carrier light kit, part #6504.
WARNING: Do not lubricate threads. Bolt failure may occur due to over tightening.
WARNING: Do not drill (except where specified for license plate mounting) or weld to this product
WARNING: With a 5000 lb rated receiver can carry a maximum 500 lb load. Only in down position.
7507IN - 07FEB02A PCN5900 © 2002 DRAW-TITE PRODUCTS, INC. Litho in USA
TOOLS REQUIRED
7/16” WRENCH
9/16” WRENCH
PHILLIPS SCREWDRIVER
TORQUE WRENCH
FIG. 2
REFLECTIVE LABEL (2)
FIG. 1
BE SURE REFLECTIVE LABELS ARE ON THE CORNERS OF
THE CARRIER FARTHEST FROM THE VEHICLE AS SHOWN
HERE.
LABEL PLACEMENT RIDGE
SUPPORT TUBE
REAR
SUPPORT
BRACKET
5/8” BOLT
5/8” FLAT
WASHER
5/8” FLAT
WASHER 5/8” LOCK NUT
TILT BRACKET
FIG. 2a
FIG. 2b Pull Pin & Clip
Down Position
Pull Pin & Clip
Up Position
FRONT
SUPPORT
BRACKET
Product No.
7507
SMALL PARTS
PACKAGE
13776