Draw-Tite 59762 ROOF RACK - Manual

PART No: Fitting Instructions
APE (Anchor Point Extended)
Cross Bar Kits
CARRYING CAPACITY:
Pg 1 of 2
50Kgs/
110 Lbs
Printed in China
Note: Prior to Assembly
Prior to assembling your cross bar kit check
that the kit contains all the parts you will need
to fit the cross bars. Refer to parts lists for
guidance.
Please read these instructions before assembly.
Step 1: Opening the vehicles anchor point doors.
On the vehicles roof or ditch molding you will find fore
and aft anchor point doors (fig 1).
Carefully open these doors by inserting a plastic tool in
the notch and prying the door open as shown. This will
reveal the anchor points. It is advisable to screw the
bolts into the anchor point threads at this time to clean
the threads.
Note: Take care when opening the doors to avoid
damaging the doors and the vehicles finish. Doors will
remain open and attached to vehicle while the cross bars
are on the vehicle.
Step 2: Installing Rubber Gaskets and Adaptor
Position the rubber gaskets over the anchor points
and the Anchor point door. Orient the curved relief
opening towards the outside of vehicle and centered
over the anchor point threads in the roof as shown in
(fig 2).
Ensure that the gasket is properly aligned.
If your gasket has a directional arrow this always
points toward the front of vehicle.
Place the plastic adaptors into the gasket’s recessed
top surface (fig 3).
Cross Bars
End support
Plastic adaptor
Rubber Gasket
M8 x 20mm Bolt
Clamp plate
M8 spring washer
M8 washer
L wrench
M6 x 45mm bolt
M8 hex nut
Cross bar end
caps
Tool required – 13mm or adjustable wrench
Anchor point
door
Vehicle’s
roof
Anchor point
Plastic adaptor
Vehicle’s roof
Anchor point
Rubber Gasket
Front of
vehicle
Vehicle’s roof
Location of anchor points on vehicle
Fig. 1
Fig. 2
Fig. 3
Parts list
End cap key
59761-4N REV 5-3-12
59761-4N
Under Cover
Curved relief to
outside of vehicle