Draw-Tite 118503 T-ONE CONNECTOR User Manual

Fh i d g

Advertising
background image

READ THIS FIRST:

Read and follow all vehicle warnings and

installation instructions before beginning installation.

Wear safety glasses and use all safety precautions

during installation.
LISEz CECI En PREmIER:

Lire et observer toutes les consignes de sécurité et les

instructions avant de commencer l’installation. Durant

l’installation, veiller à toujours porter des lunettes

de protection et respecter les mesures de sécurité.
LEA ESTO PRImERO:

Lea y siga todas las advertencias e instrucciones

de instalación del vehículo antes de empezar la

instalación. Use gafas de seguridad y todas las

precauciones de seguridad durante la instalación.

118503-037

Rev. A

05/13/2010

Installation Instructions

Directives de montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T

Acura zDX

ENGLISH

TOOLS REQUIRED:

Trim Panel Remover, 10mm Socket & Ratchet or

10mm Wrench, Drill (3/32” Drill Bit), Test-probe

1. Open rear passenger side door and fold rear

seat down

d

. Remove passenger side rear door

threshold plate to locate bolt holding passenger

side seat bolster

e

.

2. Remove bolster by removing 10mm bolt and

pulling straight up on bolster being careful not to

damage the clips holding it in place

f

.

3. Locate grey 8 pin tow plug behind bolster it will

be taped to vehicle harness with blue tape

g

.

Insert the T-Connector harness into the vehicle’s

Tow-Plug harness and lock into place.

4. On passenger side, locate existing ground stud.

Loosen 10mm bolt, place screw eyelet on stud

and re-tighten bolt

g

.

5. WARnInG

All connections must be complete for the Trailer

Tow Harness to function properly. Test and

verify installation with a test light or trailer once

installed.

6. Route the 4-Flat through the passenger’s side

trim panel into rear storage compartment and

store there when not in use

h

.

7. Reinstall the plastic trim panels, threshold,

storage covers, floor covering and other items

removed during installation, being careful not to

pinch or cut the wires.

e

8. Locate the vehicle’s Passenger Compartment

Fuse Panel located under the hood behind the

windshield washer fill tube. Insert both 7.5 amp

fuses into slot #9 and #11 in the fuse box

i

.

WARnInG

Overloading circuit can cause fires. DO NOT

exceed lower of vehicle manufacturer rating or:

• Max. stop/turn light: 1 per side (2.1 amps)

• Max. tail lights: (5.6 amps)

Read vehicle’s owners manual &

instruction sheet for additional information.

f

h

i

d

g

Advertising