Draw-Tite 118406 T-ONE CONNECTOR - Manual

5. On the passenger’ s side locate the vehicle's
Positive (+) battery cable on Fuse Box h .
Using a wrench or socket, remove the nut
and place the ring terminal with
y ellow wire
on stud. Replace the nut and tighten. Install
the 10-amp fuse into the fuse holder.
W ARNING
All connections m ust be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
6. Near center of v ehicle, below trunk threshold,
clean a flat area using a mixture of rubbing
alcohol and water. Mount the T-Connector
black box using double-sided tape provided.
7. Secure the remainder of the T-Connector
harness with the cable ties provided, to
prevent damage or rattling and being careful
to avoid any areas that would pinch, cut
or melt the wire.
8. Replace car pet, wing nuts and any other
clips or panels that were removed during
installation being careful not to cut or pinch
the wires.
NO TE
Store 4-Flat connector in rear cargo area
when not in use.
W ARNING
Ov erloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (5.6 amps)
Read vehicle's owners manual & instruction
sheet for additional information.
ENGLISH
Tools Recommended:
10mm Soc ket & Ratchet or 10mm Wrench,
Drill (3/32” Drill Bit), Philips Head Screwdriver
1. Locate the v ehicle wiring inside the vehicle's
trunk. Start by removing each of the plastic
wing nuts located behind the taillights
de .
Carefully pull back the carpet and floor
trim panel to expose the vehicle’s taillight
wiring
f .
2. Beginning with the passenger's side , slide
the red locking tab on the harness connector
to the unlocked position and disconnect the
wire harness from sockets. There will be
connection points matching the ends of the
T-Connector adapter. All connector surfaces
should be clean and free of dirt. Attach each
end to the T-Connector containing the
green
wire . Be sure that connectors are fully
inserted with locking tabs in place.
3. Route the connector containing the y ellow
wire do wn the threshold to the driver side
of the vehicle g . Push the wiring between
the vehicle body and carpet. Repeat step 2
for T-Connector end with the
y ellow wire .
4. Locate a suitab le grounding point near the
connector such as the vehicle's frame or
cross member. (Do not drill into vehicle floor
or bed.) Clean dirt and rustproofing from
area. Drill a 3/32" hole and secure
white
wire using e yelet and screw provided.
CA UTION
V erify what is behind any surface prior
to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into any
exposed surfaces.
18406-037 Rev. B 02/21/06
READ THIS FIRST:
Read and f ollow all instructions carefully
before beginning installation.
LISEZ CECI EN PREMIER:
Lire et suivre toutes les instr
uctions
attenrivement avant le montage.
LEA ESTO PRIMERO:
Lea y siga todas las instr ucciones cuidadosa-
mente antes de iniciar la instalación.
•
d
•
f
•
g
•
e
Installation Instr uctions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
•
h