Draw-Tite 118438 T-ONE CONNECTOR User Manual

Draw-Tite For the car

Advertising
background image

4.

Locate fuse compartment on passenger
side kick panel, near glove box

h. Open

fuse compartment and place 7.5 amp fuse
provided into fuse position #5 in fuse box

i.

Attach the fuse label to fuse cover in position
#5

j. Close fuse compartment.

WARNING

Do not use larger fuse.

WARNING

Replacing fuses that exceed 7.5 amps could
result in damage of the vehicle and or trailer.

5.

Reposition passenger side panels, trays and
trunk floor panels and reattach the threshold.

WARNING

All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.

WARNING

Overloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (4.2 amps)
Read vehicle's owners manual & instruction
sheet for additional information.

FUSE OPTI

ON

7.5 A

1 2 3

4 5 6

7 8 9

Installation Instructions

Directives de Montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T

118438-037

Rev. A

05/31/07

ENGLISH

TOOLS REQUIRED:

Trim Panel Remover, Pliers

1.

Open the vehicle’s rear tailgate. Remove
cargo liner and threshold. Set aside all items
removed being careful not to damage parts.
Remove the passenger side rear cargo area
trim panel so it can be pulled away from the
vehicle to locate the vehicle’s black electric
junction box

d.

2.

Plug the grey connector into the mating
connection in the top right corner of the
electric junction box

e. Mount white ground

wire to existing ground stud next to the
electric junction box

f. Mount the black

box using the double-sided tape provided
inside the passenger side trim panel on
clean flat surface.

WARNING

Make sure all other ground connections are
secure when removing and reattaching the
ground stud.

3.

Route 4-Flat wire across to drivers side
under threshold and cable tie to factory
wiring harness. Route under driver side
trim panel and store in jack compartment
for future use

g.

d

h

i

j

g

READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.

LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.

LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.

f

e

Advertising