Draw-Tite 118427 T-ONE CONNECTOR - Manual

6. On the driver’s side, locate a suitable
grounding point near the connector such
as an existing ground stud or drill a 3/32”
hole and secure the white wire using the
eyelet and screw provided. (Do not drill
into vehicle floor or bed.) Clean dirt and
rustproofing from area.
CAUTION
Verify what is behind any surface prior
to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.
WARNING
All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
7. Reinstall the threshold, trim panel, cargo
net and cover.
8. Store 4-Flat connector in rear cargo area
when not in use.
WARNING
Overloading circuit can cause fires. DO
NOT exceed lower of towing manufacturer
rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (5 amps)
Read vehicle's owners manual & instruction
sheet for additional information.
118427-037 Rev. A 12/15/06
ENGLISH
TOOLS REQUIRED:
Trim Panel Remover, 10mm Socket
& Ratchet or 10mm Wrench,
Drill (3/32” Drill Bit), 1/4" socket
1. Open the rear door of the vehicle and
temporarily remove the rear threshold, cargo
net and cargo cover to allow access of the
rear interior trim panel on the driver’s side
d.
NOTE
It may be helpful to fold rear seat forward.
2. Using a trim panel remover tool carefully
pull back the interior trim panel on Driver’s
side
e.
3. Locate the vehicle's white trailer tow plug,
located behind the trim panel removed in
step 2
f.
4. Check to see that the mating surfaces of
the vehicle wiring connectors match the
T-Connector ends. All connector surfaces
should be clean and free of dirt.
5. Insert the T-Connector harness into
the vehicle’s Tow-Plug harness and
lock into place
g.
•
d
•
e
•
g
•
f
READ THIS FIRST:
Read and follow all vehicle warnings and
installation instructions before beginning
installation. Wear safety glasses and use
all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité
et les instructions avant de commencer l’installa-
tion. Durant l’installation, veiller à toujours porter
des lunettes de protection et respecter les
mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.
Installation Instructions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
HONDA CRV