Draw-Tite 118624 T-ONE CONNECTOR User Manual

English

Advertising
background image

ENGLISH

TOOLS REQUIRED:

Trim Panel Remover, Drill (3/32” Drill Bit),

Philips Head Screwdriver, Test-probe

1. Locate the vehicle’s towplug located under

the vehicle on the passenger side. Locate the

opening to the right of the vehicle muffler.

Reach up into opening to locate the vehicle’s

grey towplug

d

. Disconnect the mating

protective cover and discard. Connect the

towplug harness into mating harness.

Check to see that the mating surfaces of

the wiring connectors match. All connector

surfaces should be clean and free of dirt.

WARNING

All connector surfaces should be clean and

free of dirt. Be careful not to damage the

locking tabs and be sure that connectors

are fully inserted with locking tabs in place.

2. Locate a suitable grounding point. Drill a

3/32” hole and secure the

white wire using

the eyelet and screw provided. Do not drill

into any exposed surfaces.

CAUTION

Verify what is behind any surface prior to

drilling to avoid damage to the vehicle and/

or personal injury. Do not drill into any

exposed surfaces.

3. Mount the 4-Flat end in an accessible location

with a bracket or electrical box (not included).

WARNING

Overloading circuit can cause fires. DO NOT

exceed lower of vehicle manufacturer rating or:

• Max. stop/turn light: (7.5 amps)

• Max. tail lights: (7.5 amps)

Read vehicle’s owners manual &

instruction sheet for additional information.

Installation Instructions

Directives de Montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T

118624-037

Rev. A

2/4/2014

READ THIS FIRST:

Read and follow all vehicle warnings and installation

instructions before beginning installation. Wear safety

glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:

Lire et observer toutes les consignes de sécurité et les

instructions avant de commencer l’installation. Durant

l’installation, veiller à toujours porter des lunettes de

protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:

Lea y siga todas las advertencias e instrucciones de

instalación del vehículo antes de empezar la instalación.

Use gafas de seguridad y todas las precauciones de

seguridad durante la instalación.

PAGE 1 OF 3

d

Range Rover Evoque

Advertising