Draw-Tite 118456 T-ONE CONNECTOR - Manual

5. Route the T-Connector end with green
wire to the passenger ‘s side behind
the panels and along the threshold.
Repeat step 4 using the T-Connector
end containing the green wire.
6. Locate a suitable grounding point near the
connector. (Do not drill into vehicle floor or
bed.) Clean dirt and rustproofing from
area. Drill a 3/32” hole and secure white
wire using eyelet and screw provided.
CAUTION
Verify what is behind any surface prior
to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.
WARNING
All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed. For initial test, reset vehicle
electrical system by temporarily removing
the key from the ignition.
7. Clean a flat area using a mixture of
rubbing alcohol and water. Mount the
T-Connector black box using cable ties
or double-sided tape provided. Secure
the remainder of the T-Connector harness
with the cable ties provided, to prevent
damage or rattling and being careful to
avoid any areas that would pinch, cut
or melt the wire.
8. Reinstall the plastic trim panels, threshold,
storage covers, floor covering and other
items removed during installation, being
careful not to pinch or cut the wires.
WARNING
Overloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: 1 per side
(2.1 amps)
• Max. tail lights: (5.0 amps)
Read vehicle’s owners manual & instruction
sheet for additional information.
ENGLISH
TOOLS REQUIRED:
Test-probe, Trim Panel Puller,
Drill (3/32” Drill Bit), Philips Screwdriver
1. Open rear hatch. Temporarily remove the
rear threshold plate, storage covers, jack
and floor covering
d e f g.
2. Partially remove the rear interior trim
panels on both the driver and passenger
side of the vehicle.
3. On the driver and passenger sides of the
vehicle, locate the vehicle’s taillight wiring
harness. The taillight wiring harness will
have a connection point, on both sides,
matching the ends of the T-Connector
h.
Separate this connector, being careful not
to break the locking tabs. All connector
surfaces should be clean and free of dirt.
4. On the driver’s side, insert the T-Connector
end, with the yellow wire, between the
vehicle wiring connectors and lock into
place. Be careful not to damage the
locking tabs and be sure that connectors
are fully inserted with locking tabs in place.
•
e
•
d
•
f
•
g
•
h
118456-037 Rev. A 01/29/08
READ THIS FIRST:
Read and follow all vehicle warnings and
installation instructions before beginning
installation. Wear safety glasses and use
all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité
et les instructions avant de commencer l’installa-
tion. Durant l’installation, veiller à toujours porter
des lunettes de protection et respecter les
mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.
Installation Instructions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
Suzuki Grand Vitara