eLine Technology SIP-B-R - Manual (Page 6)

1 2
Getting Started
1. GETTING STARTED
The system comes with the following
components:
• 1 x Camera
• 1 x Mounting Screw Kit
• 1 x Allen Key
• 1 x RJ45 Coupler
• 1 x BNC Test Cable
• 1 x Mounting Template
• 1 x Quick Start Guide
• 1 x Instruction Manual
• 1 x Software/Documentation CD
Mounting Screw Kit:
• 3 x mounting screws
(PA4 30mm)
• 3 x drywall anchors
Allen Key RJ45 Coupler
BNC Test Cable
1.1 Default Camera Username, Password, and Ports
Username: admin
Password: admin
Ports: 80 (HTTP), 30001 (Control/Streaming), 8080 (RTMP), 554 (RTSP)
IP Address: DHCP Enabled by Default (Router will automatically assign IP
address)
NOTE: Once you have completed the basic setup of the camera, it is
recommended to configure a static IP address. This will prevent the camera
IP address changing in the event of a power failure. For details, see “6.7.1
Local Network” on page 26.
Getting Started
1.2 Camera Interior Overview
Access panels. Are at underside of the camera body, using the supplied key
you open by unlocking the two screws, note that each has a rubber hold so will
not fall off. Model with fixed focus lens has no front panel adjustment as if not
required.
With Micro sd Card slot*. Camera reset & service video connector.
1.2.1 Functions of Status LED’s
• No LED status available on this model.
Lens Zoom &
focus adjust
eLine Technology eLineTechnology.com