EXP Computer EXP Serial Card Dual COM port - Manual

Dual Ports Serial PC Card Installation Guide
DOC. NO: LD-5118
SOFTWARE INSTALLATION
For Windows 95
Insert the Serial PC Card into the PCMCIA socket of your notebook computer.
Once the Serial PC Card is inserted properly, Windows 95 will detect the new device
automatically and prompt you a screen to begin the software installation.
Insert the Serial PC Card device driver diskette into your floppy disk drive. Click
“Next” button to continue.
Press ENTER or click Finish to continue. If the working directory is not drive A, click
Other Locations for manually searching for a driver. The installation will proceed
automatically.
You may go to the Device Manager to check if the device driver is installed properly
or to make changes to the configurations as the following figure illustrates. (Go to My
computer. Click mouse right button, click Property. Select Device Manage.)
For Windows NT
1. Insert the Serial PC Card device driver to your floppy disk drive.
2. In the Start menu, click Run.
3. A dialog box will appear. Type in A:\WINNT\SETUP.EXE.
4. From the main group menu, you may go to Control Panel to check if the device
driver is installed as the following screen displays the icon.
5. Double click the Serial PC Card (2P) Settings icon, the following dialog box
will appear to display the properties. Click OK to use the default settings or
you may change the settings if there is any conflicts.
6. Remember to reboot your computer for the first time installation or if you are
making any changes to the configuration.