EXP Computer PowerView - Manual

POWERVIEW VIDEO ENHANCER QUICK GUIDE
Congratulations on purchasing the PowerView Video Enhancer! Designed to
improve the output of your video display, the Video Enhancer delivers a sharper
image and more vibrant colors, while at the same time reducing eyestrain
considerably. The PowerView Video Enhancer is compatible with most systems and
can be installed on your PC in minutes!
Your Video Enhancer offers the following benefits:
1. Increased sharpness and brightness
2. Easy to install
3. Hot key toggles Enhanced mode on/off
4. No software or driver required.
Connecting the Video Enhancer
As a precaution, before you begin the following procedure, power off your PC and
disconnect the power. Locate the VGA port on the rear of your PC and disconnect
the signal cable. Then, disconnect the keyboard from the PS/2 port. Refer to Fig. 1
and follow the directions below to connect the Video Enhancer to you PC:
1. Connect the Video Enhancer’s VGA connector to the VGA port of your
PC. Tighten the securing screws.
2. Connect the monitor’s 15-pin mini D-sub plug to the Video Enhancer’s
VGA port. Again, tighten the securing screws.
3. Connect the Video Enhancer’s PS/2 connector to the PS/2 port of your PC.
4. Connect the keyboard to the Video Enhancer’s PS/2 port.
Operation
The Video Enhancer requires no software to operate; once you have connected the
Video Enhancer to your PC, you are ready to get started. To begin, power on your
PC. When the operating system loads, you won’t notice any difference in your
display output. This is because your monitor is still displaying in original mode. To
switch to Enhanced mode press the [Pause] key. The Enhanced mode LED on the
Video Enhancer will light.
Hit the [PAUSE] key to switch.
-Fig.1-