EXP Computer PD-630 - Manual (Page 10)

ENABLING 32-BIT CARD SUPPORT OF WINDOWS 95
Your system should be ready for PCMCIA socket support prior to operating
the PD TRAVELER. To check whether your computer is PCMCIA Socket
supported, first, double-click on the “System” icon from “Control Panel”
folder (you can select the “Control Panel” under “Settings” from the “Start”
menu to open the “Control Panel” folder).
Click on the Device Manager Tab. If “PCMCIA Socket” is found with a cross
(x) sign next to the PCMCIA Controller as Figure 9, it means the PCMCIA
device driver is not using 32-Bit Card Support.
Figure 9
In this case, double click on the PCMCIA Controller, and a dialog box will be
displayed as below. Please place a check mark next to the current
configuration of Device usage box, then select OK.
Figure 10
After the PCMCIA 32-Bit Card support is installed, Windows will ask you to
reboot your computer. Then you should refer to the first section titled “Using
CD-ROM Under Windows 95” to configure the PD TRAVELER.
If the PCMCIA Socket is not found, then you must add a PCMCIA socket to
your system. Please click on the “Add New Hardware” icon in the Control
Panel folder and select “PCMCIA socket”. Select the appropriate type of
PCMCIA Controller that matches with yours and follow the on-screen
instructions.