Biamp 801i - Manual (Page 6)

4
Remote Control
Remote: The output level of an 801i mixer can be remotely controlled via an external potentiometer (5k~50k ohm linear taper) or ramp
control voltage (0~+10VDC). An RP-L1 remote control panel is available as an option (see diagram below). Potentiometers are wired high
(V), wiper (C), and low (
d ). Ramp voltage is wired positive (C) and ground( d ). The Remote port of the 801i mixer must be enabled
before remote control of output level is possible (see Master DIP Switches on pg. 3). Remote control does not change physical settings on
the 801i mixer, it only attenuates from the maximum level settings established at the mixer.
C V
green (to ' ')
red (to 'C')
white (to 'V')
low (ccw)
wiper
high (cw)
cw ccw
w
REMOTE
RP-L1
25k
Ω
linear