BJM Pumps SV75-575T - Manual (Page 7)

7
SV1500 9.3 275 ISO 32 NSF Food Grade Mineral Oil
SV08 9.3 275 ISO 32 NSF Food Grade Mineral Oil
SV08C 9.3 275 ISO 32 NSF Food Grade Mineral Oil
SV15 9.3 275 ISO 32 NSF Food Grade Mineral Oil
SV22 3.4 100 ISO 32 NSF Food Grade Mineral Oil
SV37 3.4 100 ISO 32 NSF Food Grade Mineral Oil
SV55 27 800 ISO 32 NSF Food Grade Mineral Oil
SV75 27 800 ISO 32 NSF Food Grade Mineral Oil
Note: EPDM seals will use Propylene glycol instead of ISO 32 NSF Food Grade Mineral
Oil.
PUMP INSTALLATION
SV Series pumps have been evaluated for use with water or water based solutions.
Please contact the manufacturer for additional information.
Risk of electric shock. Pump models; SV400, SV750 (115v) are
supplied with a grounding conductor and grounding-type attachment plug. 230V single
phase pumps and all three phase pumps do not come with electric plug connectors. To
reduce the risk of electric shock, be certain that it is connected only to a properly
grounded, grounding-type receptacle.
Lifting:
Attach a rope or lifting chain (not included) to the handle (or lifting rings) on the top of
the pump.
Do not lift the pump by the power cable or discharge hose/piping.
Proper lifting equipment (rope/chain) must be used.
POSITIONING THE PUMP
BJM Pumps, SV Series pumps are designed to operate fully or partially submerged.
Avoid running the pump dry for extended periods of time. Refer to data sheet for
minimum submersion depth for your particular model. Data sheets can be obtained
online at
www.bjmpumps.com or by calling BJM Pumps, LLC at 860-399-5937. As a
general rule, SV Series side discharge pumps can pump down to a level above the
suction cover. Pumping lower than the cover will permit air to enter the pump and
cavitate, lose prime or become air bound.