Burkert Type 2000 - Manual (Page 3)

3
Intended use
Type 2000 INOX
2.1. Symbols
Warning to prevent death or serious injuries:
DANGER!
Warns of an immediate danger!
WARNING!
Warns of a potentially dangerous situation!
Warning to prevent moderate or minor injuries:
CAUTION!
Warns of a possible danger!
NOTE!
Warns of damage to property!
Important tips and recommendations.
→
designates a procedure which you must carry out.
3. INTENDED USE
Angle seat valve Type 2000 INOX is designed to control the flow-rate
of liquid and gaseous media.
• Observe the permitted application conditions for using the equipment.
• Operate only when in perfect condition and pay attention to correct
storage, transportation, installation and operation.
4. BASIC SAFETY INSTRUCTIONS
Danger – high pressure!
• Turn off the pressure and vent the lines before loosening lines
or valves.
Risk of electric shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations
for electrical equipment!
Risk of crushing from moving pneumatic connection!
• When opening and closing the device, do not touch the moving
pneumatic connection.
• Do not reach into the area immediately above and below the
control air connection.
Risk of water hammer when flow inlet over seat!
• When flow inlet over seat, do not use angle seat valve for liquid
media due to the risk of water hammer.
Risk of burns/risk of fire if used during long-term operation
through hot device surface!
• Do not touch the device with bare hands.
• Keep the device away from highly flammable substances and
media.
english