Burkert Type 2658 - Manual (Page 15)

15
Installation
insTallaTiOn 7.
safety instructions 7.1.
WARNING!
danger - improper assembly/installation!
Improper installation or assembly may result in injuries as well as
damage to the device and the area around it.
Installation and assembly may be carried out by authorised •
technicians only and with the appropriate tools!
WARNING!
danger due to unintentional activation of the equipment!
Unintentional activation of the equipment during installation work
may result in injuries and/or damage.
Take appropriate measures to prevent the equipment from •
being unintentionally activated.
CAuTIoN!
danger when using volatile media!
If volatile media such as hydrogen peroxide (H2O2) or sodium
hypochlorite (NaCIO) are used, there is a serious risk of injury. The
media may evaporate causing a dangerous pressure increase in
the empty space between the ball and the housing.
If you have any questions regarding safety, please contact our •
sales offices (telephone no. or address can be found on the last
pages of these operating instructions).
7.2. installation process
Depending on the material, install the plastic ball valve according to
the respective installation process.
adhesive joints (pVc-u, pVc-c) 7.2.1.
Procedure for valve and fitting adhesive joints:
Chamfer the pipe ends by approx. 15°.
→
Remove all traces of dirt and grease from the entire length of the
→
adhesive joint. Use a clean, absorbent paper towel or a paint brush
which is wetted with cleaning agent.
Repeat the same process on the inside of the socket. Leave the
→
surfaces to dry for several minutes before applying the adhesive.
english
Type 2657