Burkert Type 6606 - Manual (Page 3)

8
note!
Electrostatic sensitive components / modules!
The device contains electronic components which react
sensitively to electrostatic discharge (ESD). Contact with
electrostatically charged persons or objects is hazardous
to these components. In the worst case scenario, they will
be destroyed immediately or will fail after start-up.
Observe the requirements in accordance with •
EN 61340-5-1 and 5-2 to minimise or avoid the possibility
of damage caused by sudden electrostatic discharge!
Also ensure that you do not touch the electronic compo-
•
nents when the power supply voltage is present!
The solenoid valves Type 6126 and Type 6606
were developed with due consideration given to
the accepted safety rules and are state-of-the-art.
Nevertheless, dangerous situations may occur.
Failure to observe this operating manual and its operating
instructions as well as unauthorised tampering with the
device release us from any liability and also invalidte the
warranty covering the device and accessories!
english 9
general infOrmaTiOn 5.
scope of supply 5.1.
Check immediately upon receipt of the delivery that the con-
tents are not damaged and that the type and scope agree
with the delivery note and packing list.
If there are any discrepancies, please contact us immediately.
germany
Contact address:
Bürkert Fluid Control Systems
Sales Center
Chr.-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tel. + 49 (0) 7940 - 10 91 111
Fax + 49 (0) 7940 - 10 91 448
E-mail: [email protected]
international
Contact addresses can be found on the final pages of the
printed operating instructions.
And also on the internet at:
www.burkert.com Bürkert Company Locations
english 9
10
Warranty 5.2.
This document contains no promise or guarantee. Please
refer to our general terms of sales and delivery. The warranty
is only valid if the device is used as intended in accordance
with the specified application conditions.
The warranty extends only to defects in the
solenoid valves Type 6126 and Type 6606 and
their components.
We accept no liability for any kind of collateral
damage which could occur due to failure or mal-
function of the device.
approvals 5.3.
The approval rating on the Bürkert lables concerns to
Bürkert products.
Devices that carry the e1 marking have been approved by
the Federal Office for Motorised Transport under the type
approval number
e1*72/245*2006/96*5791*00
and will be brought into circulation with the indicated
approval designation.
english 11
You can obtain an excerpt from the type approval from the
address below
Bürkert Werke GmbH & Co KG
Zulassungsbeauftragter
Christian-Bürkert-Str.13-17
D-74653 Ingelfingen
information on the internet 5.4.
Operating instructions and data sheets for Types 6126 and
6606 can be found on the Internet at:
www.burkert.com Documentation Type
english 11
Type 6126 / 6606