Burkert Type 8111 - Manual (Page 17)

5 Open the terminals with a screwdriver
6 Insert the wire ends into the open terminals according to the wiring
plan
7 Tighten the terminals with a screwdriver
8 Check the hold of the wires in the terminals by lightly pulling on
them
9 Tighten the compression nut of the cable entry. The seal ring must
completely encircle the cable
10 Screw the housing cover back on
The electrical connection is finished.
5 .3 Wiring plan, single chamber housing
N
N A M U R
( I E C 6 0 9 4 7 - 5 - 6 )
m a x .
m i n .
S i m u l .
+ -
0,5 g / cm3
0,7 g / cm3
3
6
5
7
1
2
4
Fig. 8: Electronics and connection compartment, single chamber housing
1 Control lamp
2 DIL switch for characteristics reversal
3 DIL switch for sensitivity adjustment
4 Ground terminal
5 EMC filter element
6 Simulation key
7 Connection terminals
For connection of the amplifier according to NAMUR (IEC 60947-5-6,
EN
50227). You can find further information in the "Technical data".
Electronics and connec-
tion compartment
Wiring plan
LEVEL SWITCH 8111 • with NAMUR output 17
5 Connecting to power supply
32048
-
EN
-
120418