ELRO HA68S Multi-zone professional alarm system USERS MANUAL - Manual (Page 33)

Default setting: OFF 30s
Scroll through the menu until ‘2-7 Error Beep’ is displayed. The current setting
will also be displayed.
To change the setting press .
Press to enable Warning Beep and enter the required beeping interval in
units of 10s. e.g. enter 6 for a 60s beeping interval (max. setting 25, i.e. 250s)
Press to disable Warning Beep.
ALARM RELAY
This setting controls the operation period for the NO/NC hardwired output relay
contacts following an alarm condition being initiated.
If this is set to ‘ON until Disarm’ then the relay will latch and remain On until
the system is next disarmed.
Default setting: ON until Disarm
Scroll through the menu until ‘2-8 Alarm Relay’ is displayed. The current
setting will also be displayed.
To change the setting press
Scroll through available options, (2s, 30s, 60s, 180s, 300s and ON until Disarm )
until the required setting is displayed and then
Press to save and exit, or
Press to exit without saving.
CALL ABORT
This feature, if enabled, will delay the activation of the telephone dialer following
an alarm for a period of approx. 30s to allow the system to be disarmed.
Default setting: OFF
Scroll through the menu until ‘2-9 Call Abort’ is displayed. The current setting
will also be displayed.
To change the setting press .
Press to enable Call Abort, or
Press to disable Call Abort.
-31- -34-
Scroll through the menu until ':3 Learning ID2' is displayed.
Three possibilities would happen as follows:
Learning OK - the ID code was learned by the Control Panel successfully.
Time Out
- the time involved for learning the ID code is 60s. During this
duration, fail to press the button on the remote control
would result in overdue programming.
ID Duplicate - the same ID code was learned by the Control Panel beforehand.
Scroll through the menu until ':4 Keypad2 Work'
is displayed and press .
Press to enable the Wireless Keypad, or
Press to disable the Wireless Keypad.
ZONE LOCKOUT
This feature, if enabled, prevents a single zone from triggering an alarm
condition more than three times before the system is disarmed. However, if
disabled, there is no limit on the number of times a zone can trigger an alarm
condition.
Default setting: ON
Scroll through the menu until ‘2-15 Zone Lock’ is displayed. The current setting
will also be displayed.
To change the setting press .
Press to enable Zone Lockout, or
Press to disable Zone Lockout.
EN EN