ELRO HIS20S Security & home automation system EXPANDED USERS MANUAL - Manual (Page 44)

42
Green Home setting is designed specially for home
automation types of devices, i.e. device with 433 MHz
radio frequency. Scroll through the top level
programming menu until ‘6. GREEN HOME’ is
displayed and press .
Note:
To return to top level programming menu, press
.
Green Control
For receiver type of devices (e.g. ON/OFF plug,
dimmer), scroll through the menu until ‘6-1 Green
Control’ is displayed.
Enter green control number (1-32) to be configured and
press .
Code Learning
This enables the green control learns ID code from the
Home Box.
Firstly, press the knob of the receiver for 3 seconds
until the LED flashes rapidly, and then release the knob.
The receiver is waiting to learn the ID code.
Set the Smart Home Box into code learning status,
scroll through the menu until ‘:1 Link Panel to
Control’ is displayed and press .
Press On/Off knob on the receiver to receive ID code
from the Smart Home Box instantly.
Two possibilities would happen as follows:
Sending ID code Wait 2s
– the ID code was emitted
from Smart Home Box.
Wait 2 Second Test – the code was learned by the
receiver. The receiver turns On/Off automatically
once after learning was successful.
Note:
DO NOT connect the receiver to light fixture,
electrical fans or any other appliance to avoid possible
dangers which might be caused during this 2-Second
Test.
Alarm Trigger
This controls devices of a group to turn on/off once
alarm is on. Scroll through the menu until ‘:2 Alarm
Trigger’ is displayed.
Default setting: off
To change the setting press .
Press to enable the devices, or
Press to disable the devices.
Note: Please pay attention to the appliance that is
connected to the green control. If Alarm Trigger is
set to ON, the green control will activate automatically
once the alarm is triggered and the appliance such as
coffee maker connected to the green control will start
cooking. It could be dangerous if no one is at home.
All Turn ON
This sets the receivers of this group is to turn ON/OFF.
Scroll through the menu until ‘:3 All On’ is displayed.
Default setting: OFF
To change the setting press .
Press to turn on the group devices, or
Press to turn off the group devices.
SMS Remote (for GSM Gateway)
It enables/disables the device to be controlled remotely.
For instance, if the green control is connected with a
coffee maker and this feature is set to OFF, then this
coffee maker cannot be set to ON via remote control.
To enable/disable this function, scroll through the menu
until ‘:4 SMS Remote’ is displayed.
Default setting: OFF
To change the setting press .
Press to enable SMS Remote, or
Press to disable SMS Remote.
Model Type
To select device type, scroll through the menu until ‘:5
Model Type’ is displayed and press .