Managing your camera using your smartphone, Camera installation, Adjusting the camera angle – ELRO C705IP WiFi network camera User Manual
Page 21
21
• Click on 'submit' after this.
The camera restarts automatically when you click 'submit'. This takes approximately 30
seconds.
• Close your browser and camera tool after the computer has restarted.
• Remove the network cable from the camera.
• Open the IP camera tool and click on your camera's address. You can now operate your
camera wirelessly.
• If your camera is not in the camera tool window, right click on the tool window, then
press the "refresh camera list" option.
4.6. Camera installation
!
Please note! Make sure that the camera functions properly in the chosen location
before starting installation.
You can choose to place the camera on a flat surface, or to attach the camera to the
location of your choice with screws.
To mount the camera using screws, perform the following steps:
• Screw in the base of the camera with the aid of the 4 included screws
5
.
!
Please note! If the surface is too hard for the screws (stone/concrete), you will need to
drill holes and use the screw plugs which are included.
• Screw the camera back onto the base.
6
4.7. Adjusting the camera angle
• Unscrew the knob on the side of the base
7
.
• Then adjust the camera angle and tighten the knob again
8
.
5. Managing your camera using your
smartphone
Make sure your camera(s) is/are connected to your smartphone via the ELRO INSTALL App
(see section 4.1 and 4.2).
5.1. You can view your camera image on your Android
smartphone
• On the initial screen of the App press the camera you want to manage.
N
The camera
picture appears on your smartphone.
O
• Swipe your finger across the screen to zoom in and out and to move the camera image.
!
Attention! If you do not have a picture it is possible that your wireless connection is
not fast enough. In that case change the resolution of your camera image (see section
5.1.1)
The camera screen provides a number of options:
• Press the "Snapshot" button
O1
to make a snapshot of your camera image.
• Press the "mute/listen/speak" button
O2
to adjust your sound settings.