Specifications – Audio-Technica ARTIST ELITE 4000 User Manual

Page 26

Advertising
background image

Specifications

OVERALL SYSTEM

UHF Operating Frequency

Band C: 541.500 to 566.375 MHz
Band D: 655.500 to 680.375 MHz

Number of Channels

200 total per band

Frequency Stability

±0.005%, Phase Lock Loop frequency
control

Modulation Mode

FM

Normal Deviation

±5 kHz

Operating Range

300' typical

Operating Temperature Range

41° F (5° C) to 113° F (45° C)

Frequency Response

70 Hz to 15 kHz

AEW-R4100 & AEW-R5200 RECEIVERS

Receiving System

Dual independent RF sections, automatic-
switching diversity

Image Rejection

60 dB typical

Signal-to-noise Ratio

115 dB at 40 kHz deviation
(IEC-weighted, 75 kHz maximum
modulation)

Total Harmonic Distortion

≤1% (10 kHz deviation at 1 kHz)

Sensitivity

20 dBµV (S/N 70 dB at 5 kHz deviation,
IEC-weighted)

Intermediate Frequency

65.75 MHz, 10.7 MHz

Audio Output (ATTN switch at “0”)

Microphone

25 mV (at 1 kHz, ±5 kHz deviation,
10k ohm load)

Instrument

50 mV (at 1 kHz, ±5 kHz deviation,
10k ohm load)
AEW-R5200: Both outputs are transformer
isolated and balanced

Audio Output Attenuator (ATTN)

Three-position switch: 0 / -6 / -12 dB

Output Connectors

Microphone

XLRM-type

Instrument

AEW-R4100

1

/

4

" (6.3 mm) TS unbalanced phone jack

AEW-R5200

1

/

4

" (6.3 mm) TRS balanced phone jack

Headphone Output

Connector

1

/

4

" (6.3 mm) TRS (“stereo”) phone jack

Power Output

10 mW + 10 mW at 1 kHz, ±5 kHz
deviation into 32 ohms; maximum output,
220 mW + 220 mW into 32 ohms.
AEW-R5200: Headphones switchable
between Channel 1 and Channel 2

External Mute (AEW-R5200)

1

/

4

" (6.3 mm) TS unbalanced phone jack,

each channel

Antenna Terminal Voltage

DC 10V-12V, 20 mA (BNC-type jack)

Computer Interface (AEW-R5200)

Type

Ethernet, 10 BaseT mode

Connector

RJ-45

Proprietary Software

Supplied on CD-ROM

Power Supply

AEW-R4100

100–240V AC 50/60 Hz, 8W

AEW-R5200

100–240V AC 50/60 Hz, 15W

Pass-through AC Power Outlet

100–240V AC 50/60 Hz, 5A maximum

(AEW-R5200)

Dimensions

AEW-R4100

8.31" (211.0 mm) W x 1.74" (44.0 mm) H
x 9.26" (235.0 mm) D

AEW-R5200

18.98" (482.0 mm) W x 1.74" (44.0 mm) H
x 10.85" (275.5 mm) D

Net Weight (without accessories)

AEW-R4100

3.8 lbs (1.7 kg)

AEW-R5200

8.8 lbs. (4.0 kg)

Accessories Included

Both receivers

Detachable IEC-type AC power cable;
two flexible UHF half-wave antennas;
link cable

AEW-R4100

Rack-mount adapters

AEW-R5200

IEC-type AC pass-through cable;
front-mount antenna cables and
connectors; CD-ROM with computer
control interface software; AEW-TB44
transmitter bag

AEW-T1000 UNIPAK

TRANSMITTER

RF Power Output

High: 35 mW; Low: 10 mW, nominal

Spurious Emissions

Under federal regulations

Dynamic Range

Microphone

≥110 dB, A-weighted

Instrument

≥100 dB, A-weighted

Input Connections

High impedance, low impedance, bias

Batteries (not included)

Two 1.5V AA alkaline

Current Consumption

High: 185 mA; Low: 165 mA, typical

Battery Life

Approximately 8 hours (High); 10 hours
(Low), depending on battery type and
use pattern

Dimensions

2.60" (66.0 mm) W x 3.43" (87.0 mm) H
x 0.94" (24.0 mm) D; not including
antenna

Net Weight (without batteries)

4.4 oz (125 g)

HANDHELD TRANSMITTER

RF Power Output

High: 35 mW; Low: 10 mW, nominal

Spurious Emissions

Under federal regulations

Dynamic Range

≥110 dB, A-weighted

Microphone Element

AEW-T3300

Cardioid Condenser

AEW-T4100

Cardioid Dynamic

AEW-T5400

Cardioid Condenser

AEW-T6100

Hypercardioid Dynamic

Batteries (not included)

Two 1.5V AA alkaline

Current Consumption

High: 185 mA; Low: 165 mA, typical

Battery Life

Approximately 6 hours (High); 8 hours
(Low), depending on battery type and
use pattern

Dimensions

AEW-T3300, AEW-T5400 9.41" (239.0 mm) long, 1.97" (50.0 mm)

maximum diameter

AEW-T4100, AEW-T6100 9.33" (237.0 mm) long, 1.89" (48.0 mm)

maximum diameter

Net Weight (without batteries)

AEW-T3300

9.5 oz (270 g)

AEW-T4100

9.7 oz (276 g)

AEW-T5400

10.0 oz (285 g)

AEW-T6100

9.7 oz (275 g)

Accessory Included

AT8456a Quiet-Flex

stand clamp

In the interest of standards development, A.T.U.S. offers full details on its test methods to
other industry professionals on request.
Specifications are subject to change without notice.

27

Advertising
This manual is related to the following products: