Fluid Components International 8-66B_12-64B Series Manual CE Conformance - Manual (Page 2)

FLUID COMPONENTS INTL APPENDIX D - CE Conformance
Models 12-64/8-66 Basic Switch D - 2 Doc. No. 06EN003264 Rev. A
INSTALLATION CONFORMITY CRITERIA
Grounding
The enclosure must be grounded to earth ground through a path of less than 1 ohm.
Interconnecting Cables
All interconnecting cables between the local enclosure, power source and monitoring device shall be enclosed in
metal conduit. AC power input cabling shall be enclosed separately in conduit before entrance into the instrument
and is not to be combined with switch or monitor output cabling.
Location of CE mark documentation (European Location)
The technical documentation file part A resides at Fluid Components Intl, European Service Center, Beatrix De
Rijkweg 8, 5657 Eg Einhoven, Netherlands, Phone: 31-40-2-571-972 FAX: 31-40-2-517-809.
Location of CE mark documentation (Manufacturer Location)
The technical documentation file part B resides at the Configuration Management department of Fluid Components
Intl, 1755 La Costa Meadows Dr. San Marcos, CA. 92069 USA, Phone: 1 (800) 854-1993
FAX: 1 (619) 736-6250.