Caution – Air Oasis 9 User Manual

Page 5

Advertising
background image

Read all instructions carefully before operating

your air purifier.

Table of Contents

Introduction

1

Safety Instructions and Cautions

2

Warranty

3

Maintenance and Customer Service

4

Installation and Operation

4-5

Replacement Parts

5-6

Troubleshooting Guide

7

Important Safety Instructions

When operating electrical appliances, basic precautions should always be fol-

lowed.

WARNING To reduce the risk of fire, electric shock or injury:

• Do not use outdoors or on wet surfaces.

• Use only as described in this manual.

• Do not use with damaged cord or plug. If appliance is not working as it should,

has been dropped, damaged, left outdoors, or dropped into water, call customer

service at 1-800-936-1764.

• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

• Do not handle plug or appliance with wet hands.

• Do not put any object into openings.

• Unplug from power source before performing any maintenance or removing

front cover.

• It’s strongly recommended that only a licensed electrician or HVAC installer

properly install this unit.

CAUTION

AHPCO™ Cell contains Hg (Mercury) and should be disposed of according to

disposal laws. Find disposal centers at www.earth911.org.

If the UV lamp is broken do not touch the cell or glass with your hands.

UV lamp may be hot and could cause serious burns if not handled properly. Please

wait until the AHPCO Cell has cooled to room temperature to remove from unit.

2

Step 4

Plug the power cord into an electrical outlet. You may optionally have an

electrician wire the air purifier to your HVAC unit so that the air purifier only

operates when your HVAC fan is running. Once the unit is plugged in the

indicator light should glow to indicate the AHPCO Cell is working properly.

5

AHPCO™ Cell Replacement

Step 1

CAUTION: Before attempting to service the Air Oasis unit, be sure the

power is off and unplugged.

Remove three (3) screws at the top of

the aluminum face plate. Then slide

the face plate up and off.

Step 2

Unplug the four pin lamp connec-

tors and fiber optic cords from the

AHPCO Cell.

Advertising