Grace Digital GDI-TW4CD Tunewriter IV - Manual (Page 11)

CD RECORDING INSTRUCTIONS
10
This unit is designed to record CD-R and
CD-RW discs bearing the identification
logo “Compact Disc Recordable” or “CD-
Rewritable”,If CD’s do not confirm to this
standard, they may not record properly.
Recording Records to CD
1 Load a compatible blank CD-R or CD-RW into the
unit.
2 Press the PHONO button (6/41) to set the unit to
Phono mode.
3 Set the SPEED CONTROL SWITCH (32) to the
correct speed (33 ,45 or 78 rpm) for the selected
record.
4 Use the CUE LEVER (30) to raise the tone arm off
its rest .Move the tone arm over the record and use
the cue lever to lower it to the point you want the
recording to start.
5 Press the RECORD button (13/56) .Then press
“ PLAY/PAUSE” button
(17/53) .The CD will
begin recording.
6 Once the first side of the record is finished ,
press the STOP
(18/55)
button. The display will
change “PHONO”.
7 Turn the record over and repeat steps 4-6 to
record the other side.
8 After recording is completed, press the
STOP
(18/55)
button . The display then change to
“PHONO”.
9 Once you have finished the recording ,press the
CD button
(7/40)
then press FINALIZE button
(14/49)
.
Then press PLAY/PAUSE (17/53)
to finalize.
10 Once the CD has been finalized, the unit will
return to Phono mode and the display will show
“PHONO”. The CD door will open ,the CD is
now ready for use.
NOTE: If the CD is not finalized, it will not play in
any other CD player . Not all CD players are
compatible with CD-R and CD-RW ’s. Check the
owner's manual for other CD players for
compatibility.
Recording Cassettes to CD
1 Load a compatible blank CD-R or CD-
RW into the unit.
2 Press the TAPE button (5/43)
to set the
unit to TAPE mode.
3 Load a pre-recorded cassette tape into
the cassette player. Press to PLAY
button
(17/53)
to get the cassette to the
point in which you want to start the
recording.
4 Once the cassette is ready and playing,
press the CD RECORD button
(13/56)
.
Then press “PLAY/PAUSE” (17/53)
. The
CD will begin recording.
5 Once the first side of the cassette is
finished , press the STOP
(18/55)
button ,
then change to “TAPE”.
6 Eject the cassette tape and flip it over to
the other side.
7 Repeat steps 4 and 5 to record the other
side of the cassette .
8 After recording is completed,press the
STOP button
(18/55)
,then change to“TAPE”.
9 Once you have finished the recording,
press the CD button
(7/40)
, then press
“FINALIZE”button (14/49)
. Then press
PLAY/PAUSE (17/53)
to finalize.
10 Once the CD has been finalized, the
unit will return to tape mode and the
display will show “TAPE” . The CD door
will open ,the CD is now ready for use.
NOTE: If the CD is not finalized. The
LCD will display "No TOC CD-R or CD-
RW. If the CD is finalized. The LCD will
display"CD-R or CD-RW.
Preparation