Andis Company AGRC - Manual (Page 4)

4
Models AGRC/AGRV/AGR+ can be used with either the cord pack or the battery.
READ THE FOLLOWiNG BEFORE CHARGiNG THiS CLippER
1. Remove the charger from the carton and plug into an AC
outlet as identified on charger unit and on carton.
2. Place the clipper in the form fitting pocket in the charger base
(Diagram B). Note that the battery pack is fitted with a slot to
align properly with the charger. Once the battery and charger
are aligned, press the battery pack firmly into the charger until
it rests at the bottom of the pocket. You may hear a click as
the charging contacts engage this is normal. The battery pack
may be charged while on the clipper, or separately. Push the
battery release button (Diagram C) on the clipper, and pull
straight out to remove the battery. NOTE: The battery pack is
designed to run the clipper for about one hour. A clean, sharp,
well-oiled blade will provide the best run time. A busy animal
shop may want an additional battery pack, so one pack is
charging while the other is running the clipper.
3. Before initial use battery pack must be charged for a
minimum of one hour.
4. The charger base has two indicator lights. Below is a
description of the Sensacharge light sequences (Diagram D).
NOTE: The continuous red light may turn on at the end of the
fast charge cycle for a NiMH battery pack. This is a normal
condition and the battery pack is still ready for use. This
precaution is to prevent multiple fast charge cycles while the
battery is hot. The red light will go out after a few minutes.
Continuous Green Light (Fast Charge): Charger will fully
charge battery pack in less than one hour.
Rapid Green Blinking Light (Charging Complete): Battery pack
is fully charged.
Long Green Blinking Light (Refresh): Charger is draining
battery pack in preparation for fast charge. Please reference
the section “Use of the Refresh Feature” on page 6 for an
explanation.
Short Green Blinking Light:
a) With Continuous Red Light (Charge Standby): Battery pack
is trickle charging because it is either too hot or too cold to
accept a fast charge. Fast charging will occur once battery
pack temperature moderates.
b) Without Red Light (Charge Preparation): Battery pack is undergoing trickle charge, because it
has been drained excessively during use.
5. The clipper can be left in the charger base for an indefinite period of time. The charger will supply
only what is needed and will not damage the battery due to overcharge.
Model AGR+ With Battery Use
Tongue
Battery
Release
Diagram B
Diagram D
Diagram C