Hellwig Sway Bar 55914 - Manual (Page 3)

4. If equipped with factory sway bar mounts, assemble end links as shown in diagram above. Tighten
nut until bushings bulge slightly
5. If not equipped with factory sway bar mounts, remove lower shock bolt and attach angle brackets to
lower control arm as shown in photos (4) & (5) using 7/16-20 x 2-3/4” bolt with thick washer placed
between control arm and bracket. Torque bolt to 40-45 ft-lb.
6. Install the end link assemblies through the coined ends of the anti sway bar.
(SEE PHOTOS 2 & 3 ).
Tighten locknuts just enough so that the poly bushings start to bulge.
Do not over tighten.
7. Center sway bar in bushings and align crossbars for best fit. When satisfied with alignment of sway
bar, tighten flange nuts to 25 ft-lb.
8. Be sure that all bolts are tightened to specifications. Re-check your installation, check for clearance
on all undercarriage components; wiring, springs, fuel and brake lines.
9. Turn wheels full lock left and then right, check for clearance on tires, wheels and steering compo-
nents, brake components and hoses. If equipped with disk brakes check clearance of calipers and
hoses to shock mounting bolt, end link bracket, and end links.
10. After one week of driving recheck your installation. Re-check on regular basis thereafter.
ATTENTION INSTALLER: BE SURE THAT THE CUSTOMER RECEIVES THIS INSTRUCTION
SHEET, ALL IMORTANT NOTE CARDS AND THE WARRANTY
FORM
4
5
55914 ( R-55914) 02/12/2010