Hellwig Sway Bar 55868 - Manual (Page 5)

559-734-7451 800-367-5480 FAX 559-734-7460
22. Attach end links to the outer hole of the sway bar as shown in photo (10) using 7/16-20 X 2-1/2” bolts,
locknuts and washers. Align end links for best fit as shown in photo (10).
IMPORTANT NOTE –
The end link must be attached to the outer hole prior to initial use.
23. Adjust end links for best fitment of the sway bar to the vehicle.
24. When satisfied with the fit of the sway bar, torque axle U-bolts to 35-40 ft-lb.
25. Torque end link mounting bolts to 35-40 ft-lb. Tighten jam nut on end link to lock in adjustment.
26.
Bounce the vehicle checking for clearance on all under carriage components: fuel tank, shocks,
exhaust, differential, brake and fuel lines, etc. Test drive the vehicle and recheck all clearances and
the installation alignment. Adjust as needed. Re-check your installation after one week of driving and
periodically on a regular basis.
27.
The sway bar has three end link mounting holes. The end link MUST be mounted
on the outer hole for initial use. SEE PHOTO 10. For a firmer setting, use the in-
ner holes. You must use the outer mounting hole as shown in photo 10 until you are
accustomed to the vehicles new handling characteristics. After driving vehicle, a
firmer setting may be selected if desired. It is recommended that the outer hole be
used for street driving.
10
11
55868(R-55868) 12/03/09