HOMA CH_H Series - Manual (Page 10)

CH Series
START-UP REPORT
This report is designed to insure the customer that customer service and a quality product are the number one priority with Homa
Pump Technology Inc. Please answer the following questions completely and as accurately as possible. Mail this form to:
HOMA PUMP TECHNOLOGY INC.
390 BIRMINGHAM BOULEVARD
ANSONIA, CT 06401
ATTN: SERVICE MANAGER
Receipt of completed report will initiate operational warranty.
Reports that are not returned can delay or void warranty.
1.) Pump User's Name: ______________________________________________________________
Site Location: ___________________________________________________________________
Site Contract: ___________________________________________________________________
Unit Supplied By: ________________________________________________________________
2.) Homa Pumps Model__________________________________Serial No.____________________
Voltage____________ Phase_________________ Hertz____________ Horsepower__________
Method Used to Check Rotation (viewed from bottom) ___________________________________
Does Impeller Turn Freely By Hand: YES___________ NO _____________
3.) Condition of Equipment: EXCELLENT_____________ GOOD ____________ AVERAGE___________
Condition of Cable Jacket : EXCELLENT___________GOOD ____________ AVERAGE___________
Resistance of Cable and Pump Motor (measured at pump control)
U - V________________ Ohms V - W ________________Ohms U -W ________________Ohms
Resistance of Ground Circuit Between Control Panel and Outside of Pump______________Ohms
MEG Ohm Check of Insulation:
U to Ground _______________ V to Ground _______________ W to Ground ________________
4.) Condition of Equipment at Start-Up: Dry __________ Wet _____________ Muddy______________
Was Equipment Stored:______________________ Length of Storage ______________________
Describe Station Layout ___________________________________________________________
5.) Liquid Level Controls: Model_____________________________ Type ______________________
Is Control Installed Away From Turbulence?____________________________________________
Operation Check : ( IF FLOAT SWITCHES SUPPLIED).
Tip lowest float (stop float), all pumps should remain off.
Tip second float (and stop float), one pump comes on
Tip third float (and stop float ), both pumps on (alarm on simplex).
Tip fourth float (and stop float), high level alarm on (omit on simplex ).
6.) Electrical Readings :
Single Phase:
Voltage Supply at Panel Line Connection, Pump Off, L1,L2 _______L2-L3______L3-L1__________
Voltage Supply at Panel Line Connection, Pump On,L1,L2 ________L2-L3_______ L3-L1______
Amperage: Load Connection, Pump On ,L1________________L2_______________L3__________
Three Phase:
Voltage Supply at Panel Line Connection, Pump Off, L1-L2_________ L2-L3 _______L3- L1______
Voltage Supply at Panel Line Connection, Pump On, L1-L2_________L2-L3________L-3-L1______
Amperage Load Connection, Pump On, L1___________ L2___________ L3_______________
Pg. 11
Installation, Operation & Maintenance Manual