Hudson Valley Lighting BARRINGTON 324 - Manual (Page 2)

9. Slide the canopy and screwcollar ring up the chain and secure the canopy to the ceiling.
10. Install the lamps ( light bulbs). NOTE: This fixture is rated for 100 watt type A lamps. DO NOT EXCEED RECOMMENDED WATTAGE !
11. Attach the 3 chains on the ring to the hooks on the junction body.
12. Screw the pipe into the bottom of the cluster body.
13. Position the glass on the pipe and secure in place with the finial.
14. Restore power to circuit at breaker or fuse box.
FIXTURE INSTALLATION ( Semi- flush )
1. Remove the loop from the junction body. The junction body now becomes the canopy.
2. (Starting at the back), thread the 3 longest screws into the 3 equally spaced holes in the mounting ring. (The green screw is in the front).
Attach the crossbar to the outlet box. (The green screw should face the floor).
3. Thread the small hex nuts onto the screws. Adjust the screws so that they extend 3/16" beyond the surface of the canopy .
Lock the hex nuts against the crossbar.
4. Measure 6" of lead wire beyond the canopy. Cut off excess wire.
Strip the insulation off the ends of the leads exposing approx. 1/2 " of wire.
5. Follow wiring steps 6, 7 & 8 above.
6. Finish installation following steps 10 through 14.
051706
Lamp
Glass
End ball
Finial
Cluster body
Pipe