Hudson Valley Lighting BRIGHTON 3605 - Manual

www.hudsonvalleylighting.com
3605
GENERAL
1. To ensure the success of the fixture installation, the following instructions and
diagram(s) should be read and understood.
2. All electrical connections must be made in accordance with the National
Electric code and local codes and ordinances. If you are uncertain of the methods
of installing electrical wiring and lighting fixtures secure the services of a qualified
licensed electrician.
TOOLS NEEDED: Blade screwdriver, phillips screwdriver, slip joint pliers or small
adjustable wrench, wire cutter/stripper, electrical current tester, stepladder and
electrical tape. NOTE: The important safeguards and instructions outlined on this
sheet are not meant to cover all possible conditions and situations that may
occur. It must be understood that common sense, caution and care are factors
that cannot be built into any product. Caution and care must be supplied by the
person(s) installing, operating and maintaining this lighting fixture.
INSTALLATION PREPARATION
1. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE LIGHTING
FIXTURE IS TO BE ATTACHED. Turn circuit breaker to the “off position or
completely remove the fuse controlling the circuit.
2. If an existing fixture is being replaced, remove it and note to which of the wires
in the outlet box the fixture was attached. DO NOT SEPARATE MULTIPLE
TWISTED WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE
INSULATION OF OLDER WIRING. In regular circumstances the BLACK wire will
be the “Hot” lead and the WHITE wire will be the “Neutral” or “Common” lead. A
GREEN or BARE COPPER wire is the “Ground”. In older buildings it is always
good practice to reconfirm the polarity of the wiring.
3. This fixture is designed to be mounted on an octagon box. The box must be
securely mounted to the structure of the building.
FIXTURE INSTALLATION
1.Remove the fixture and parts bag(s) from the carton. Before discarding the
carton, double check packing to make certain that all parts are found.
2. Attach the mounting plate to the outlet box. (The green screw should face out).
Pull wires out of box.
3. Fasten the bare copper fixture wire to the green or bare copper wire in the box
or bare copper wire in the box to the mounting plate with green screw provided.
NEVER FASTEN THE GROUND WIRE TO THE BLACK OR “HOT” WIRE!
FAILURE TO FOLLOW THIS INSTRUCTION COULD RESULT IN SERIOUS
INJURY OR DEATH!
4. Fasten the white fixture wire to the white wire in the outlet box. Fasten the
wires to together with an approved fastener (wire nut). Starting about 1” below the
fastener, tightly wrap connection with the electrical tape so that the tape seals the
end of the fastener. Make sure that there is no exposed wire or strands that could
cause a dangerous short circuit!
5. Connect the black fixture wires to the black wire in the outlet box. Fasten the
joined wires as in step 4. Carefully push all wire connections into outlet box.
6. Place the backplate over the outlet box and fasten it by ball nuts.
7. Install the lamp(light bulb). This fixture is rated for 25w typeT5 lamp.
8. Slide the glass in to the body, and fasten the side screws by allen key to secure
the glass on the body.
9. Restore power to circuit at breaker or fuse box.
DO NOT EXCEED RECOMMENDED WATTAGE!