Hudson Valley Lighting VERNON 2408-2430 User Manual

Hudson Valley Lighting Lighting

Advertising
background image

2408,2416,2424,2430

Wall Mounting Screw

Wall

Wall Anchor














Hudson Valley Lighting, Inc.
P.O. Box 7459
106 Pierces Road
Newburgh, NY 12550
(800) 814-3993

www.hudsonvalleylighting.com

GENERAL
1. To ensure the success of the fixture installation, the following instructions and
diagram(s) should be read and understood.

2. All electrical connections must be made in accordance with the National Electric
code and local codes and ordinances. If you are uncertain of the methods of
installing electrical wiring and lighting fixtures secure the services of a qualified
licensed electrician.

3. TOOLS NEEDED: Blade screwdriver, phillips screwdriver, slip joint pliers or
small adjustable wrench, wire cutter/stripper, electrical current tester, stepladder
and electrical tape. NOTE: The important safeguards and instructions outlined on
this sheet are not meant to cover all possible conditions and situations that may
occur. It must be understood that common sense, caution and care are factors that
cannot be built into any product. Caution and care must be supplied by the
person(s) installing, operating and maintaining this lighting fixture.

INSTALLATION PREPARATION

1. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE LIGHTING
FIXTURE IS TO BE ATTACHED.

Move the appropriate circuit breaker to the “off

position or completely remove the fuse controlling the circuit.

2. This fixture is designed to be mounted on the wall.

FIXTURE INSTALLATION
1. Remove the fixture, shades and parts bag(s) from the carton. Before discarding
the carton, double check packing to make certain that all parts are found.
2. Place the fixture onto the wall, make sure the arms are horizontal.
3. Drill holes on the wall, put the anchors into the holes.
4. Mount the fixture onto the wall with the wall mounting screws.
10. Install the lamp.
NOTE: This fixture is rated for 25 watt type T10 lamp(s).

DO NOT EXCEED RECOMMENDED WATTAGE !

6. Plug the wire into the power outlet, restore power to circuit at breaker fuse box.

Advertising